center pin of RCA moving ... is this a problem

denti alligator · 1046

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline denti alligator

  • Hero Member
  • *****
    • Posts: 1156
on: June 15, 2017, 12:06:41 PM
Soldered the center pins of the RCAs and now those pins are moving. They aren't loose, but they turn in place. I'm using different RCAs, so maybe this is special to them? (see pic)

Or did I overheat them? Question is: should I replace these now, or will they be fine?


- Sam

Rega P3-24 (w/AT 150MLX) w/Groovetracer upgrades / Eros II / FLAC >J.River >DSD256 >Gustard X20 / Moreplay > Stereomour II / Klipsch Forte II w/Crites upgrades / C4S S.E.X. 2.0 +Nickel MQ Iron / Speedball Crack / Sennheiser HD600 w/Cardas cable

Offline denti alligator

  • Hero Member
  • *****
    • Posts: 1156
Reply #1 on: July 13, 2017, 03:12:03 AM
Apparently this wasn't a problem, by the way.

- Sam

Rega P3-24 (w/AT 150MLX) w/Groovetracer upgrades / Eros II / FLAC >J.River >DSD256 >Gustard X20 / Moreplay > Stereomour II / Klipsch Forte II w/Crites upgrades / C4S S.E.X. 2.0 +Nickel MQ Iron / Speedball Crack / Sennheiser HD600 w/Cardas cable

Pages: 1   Go Up
« previous next »