Kaiju Build Done

bombay317 · 2310

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline bombay317

  • Full Member
  • ***
    • Posts: 87
on: February 15, 2018, 05:11:56 PM
I finished my build.  Everything is working, but I plan on doing some nerdy things to it :)

It was a lot of fun so far and took 22 hours to build.  I build the DC filament but have not installed it yet into the system.

If I can find the time I am going to make a Bode diagram of this amp to share with everyone.

Niagara 7000
Benchmark DAC3L (XBOX1 and TV)
CA Performance w/ Satisfy Turntable
Talismann V2 CA Cartridge
Tavish Designs Adagio Vacuum Tube Phono
BHSE Amp
Stax SR-009
BeePre 300B w/ BeeQuiet and Cinemag Transformers
Kaiju 300B w/ DC Filament
Jäger Speakers
Transparent and Benchmark Cables

Offline Doc B.

  • Administrator
  • Hero Member
  • *****
    • Posts: 9666
    • Bottlehead
Reply #1 on: February 15, 2018, 06:15:17 PM
Looking good!

Dan "Doc B." Schmalle
President For Life
Bottlehead Corp.

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19787
Reply #2 on: February 15, 2018, 07:02:36 PM
That's quite the hefty load box you have there!

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline bombay317

  • Full Member
  • ***
    • Posts: 87
Reply #3 on: February 19, 2018, 03:52:05 AM
Haha, yes it is super oversized power wise, but I grabbed what was easily available and made 8 ohms. Then I just wired them and put them in a project box.

Even at max power output from the amp at 8W, that would be 2W per resistor. There is margin for sure.

Niagara 7000
Benchmark DAC3L (XBOX1 and TV)
CA Performance w/ Satisfy Turntable
Talismann V2 CA Cartridge
Tavish Designs Adagio Vacuum Tube Phono
BHSE Amp
Stax SR-009
BeePre 300B w/ BeeQuiet and Cinemag Transformers
Kaiju 300B w/ DC Filament
Jäger Speakers
Transparent and Benchmark Cables

Pages: 1   Go Up
« previous next »