Minor manual error? Lock washer on screw on bell?

AllanMarcus · 1419

0 Members and 1 Guest are viewing this topic.

Offline AllanMarcus

  • Full Member
  • ***
    • Posts: 147
  • Mainlining my way to bliss
    • My DIY Site
on: April 08, 2018, 02:04:41 PM
When attaching the power transformer on page 18, the step says to "Insert a #8 x 2" screw through each hole.". The picture shows what appears to be a #8 round lock washer between the screw and the bell. Also, that is how it's assembled on the Crack.

Does there need to be a lock washer between the screw and the bell?

This space for rent


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19750
Reply #1 on: April 08, 2018, 04:39:00 PM
There are no lockwashers in that position on the Mainline.  It's technically more correct to have them there than not, which is why they appear the way they do in the Crack 1.1, but if the hardware is nice and tight the screw will bite into the transformer cover.

-PB

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man


Offline AllanMarcus

  • Full Member
  • ***
    • Posts: 147
  • Mainlining my way to bliss
    • My DIY Site
Reply #2 on: April 08, 2018, 06:48:29 PM
Ok, thanks. I threw some lock washers I had on them anyways. I’m confident the bell won’t pop off now :-)

This space for rent