new Jagers

[joepiecuch]

Finished building a pair of these this afternoon and connected them to a recently completed BeePre and Kaiju, and, despite them standing side by side in the tiny, cluttered work room, being connected with crap wire, having no break-in on any of it and using an iPhone as source, these speakers sound amazing. My loyalty to my Straight 8s doesn't stand up to them. Thanks so much!

[Doc B.]

Yay! Well done Joe!

[elv1s]

Small world, my name is Joe and I just finished my Jagers too!

This was a great upgrade from the Tritrix I built from PartsExpress a few years ago. It feels like listening to my albums for the first time!

The image is accurate and the top end is crystal clear. The bass end was a bit low for my taste, but moving the speakers closer to the wall helped to boost it slightly.

Some notes on my build:
- I'd recommend having some clamps handy to tighten any gaps during final glue up. I waited a couple weeks between dry assembly and glue up and it looked like some of the wood moved on me.
- The inductors are a bit of a stretch on the crossover and the impedance boards, but doable.

I'm not a woodworker but here is what I did to finish the birch ply:
- generously apply minwax wood conditioner
- wipe on/off General Finishes Gel stain (American Oak) let dry overnight
- 3x wipe on General Finishes Arm r Seal (I added a little brown/red stain to tint) let dry between applications
- sand with 0000 steel wool and old english oil
- wipe off excess oil and rub with brown paper bag sheets

This will get the surface to feel like a sheet of glass. If possible do this in a temperature controlled room. I did this outdoors during a sunny day and the finish started to gum up quickly and I had to rush.

[adeep42]

Very Nice!!!!!!!!

[Deke609]

Nice job matching the stain to your existing decor!

The image is accurate and the top end is crystal clear. The bass end was a bit low for my taste ...

I don't have Jagers, but your initial listening impressions match mine when I swap in new film caps in the signal path in my amps.  The bass is always light at first and usually gets worse after about 10-20 hrs, but returns with force after 50-150 hrs depending on the type of cap (IME, metalized polypro caps seem to take the least time to "burn-in", whereas teflon caps take the longest). There must be a lot of new film caps in your crossovers - I'd give a month or two of frequent use and then reevaluate.  I suspect the sound will change a lot.


cheers, Derek