Mistake soldering RCA Jack [resolved]

Dhouse7516 · 1238

0 Members and 1 Guest are viewing this topic.

Offline Dhouse7516

  • Full Member
  • ***
    • Posts: 61
on: November 17, 2022, 03:58:39 PM
Hi all, I’m a new member in the middle of my first build. It has been going very well until tonight. After soldering the leads into the RCA jacks, I noticed that the center pin on the right RCA jack is moving up and down slightly. Pretty sure I applied too much heat and likely melted the plastic surrounding the pin. Is there a fix for this or do I just go ahead and replace the jack? Thanks much!
« Last Edit: November 23, 2022, 05:40:17 AM by Paul Birkeland »



Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19694
Reply #1 on: November 17, 2022, 06:17:31 PM
I suspect you could just use the jack as it is.  If you have a dead channel, of course that would be the first place to look!

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man


Offline Dhouse7516

  • Full Member
  • ***
    • Posts: 61
Reply #2 on: November 17, 2022, 06:29:03 PM
Thanks much, Paul. I will keep going and see where I end up.



Offline Dhouse7516

  • Full Member
  • ***
    • Posts: 61
Reply #3 on: November 22, 2022, 07:10:55 PM
Just finished my build and plugged in my hd650s. Holy shit this is gorgeous.