As shown in the picture of the initial post of this thread different output caps are used.
It looks like they're soldered to a different solder lug than in the manual.
In the manual it is 6U + 7U for one cap and 9U + 10U for the other cap.
Also the wirewound resistors are connected to 6L and 9L.
I assume the additional lugs in the picture above are added because of the size factor of the caps.
It seems like only the output caps + the wires that would normally be soldered to the original lugs are moved here.
The wirewound resistors seem to be soldered to the original lugs - this does not make a difference?
I'm asking since I also plan to upgrade my Crack with quite huge caps and therefore consider to use additional lugs.
