Static on right channel

[jcado35]

(Repost because I was on the wrong board)
I’ve had my bottlehead crack for a while now, and noticed there’s a static sound on the right channel only.
I wiggled the 12au7 tube and it made a noise on the LEFT SIDE so I re-soldered the wires and it’s quiet when I wiggle it now, BUT. The static on the RIGHT SIDE still persists.

I’ve poked every wire with a chopsticks and fixed about 3 that made a noise when moved. But the right channel static still persists.

The right static is a constant volume. Whether the volume is off or max the statics volume does not change. I unplugged the rca cords and the static persists.

I’ve re-soldered other wires but it has gotten worse I think

[jcado35]

any help please? I've cleaned the tubes pins and the static on the right channel still persists

[Paul Birkeland]

Can you post some build photos?

[jcado35]

Can you post some build photos?

[Paul Birkeland]

The solder joints on terminals 7 and 9 may need a little more solder/heat. 

If you rock either tube around while the noise is happening, does it change?

[jcado35]

The solder joints on terminals 7 and 9 may need a little more solder/heat. 

If you rock either tube around while the noise is happening, does it change?

I reheated and added more solder to 7 and 9 but the noise still persists.
The static doesn’t change when I wiggle or move the tubes around it’s just a constant static noise on the right channel only

[Paul Birkeland]

Sometimes the pins on the tubes themselves can be a bit oxidized, and cleaning them with some emery cloth or a magic eraser can take that off.

[jcado35]

Sometimes the pins on the tubes themselves can be a bit oxidized, and cleaning them with some emery cloth or a magic eraser can take that off.

Yes I bought a magic eraser and cleaned both tubes but the static persists.
BUT
I did notice that the static doesn’t start when I turn on the amp.
The static starts once the amp is heated. I timed it and it was quiet for about 2 minutes after turning the amp on. But once the tubes were hot to touch the static on the right side started.
Could it be a problem with the tubes or parts that get hot? Or a cold joint?

[Doc B.]

Considering your mention that you have used the amp for a while it might make sense to try some different tubes to see if the noise goes away. Sometimes tubes get noisy over time. It's just the nature of the beast.

[jcado35]

Update: Upgraded to the speedball last night and so far there is no static in the right channel (I hope!) , hopefully it's fixed. Not sure if it was from the parts I took out to install the speedball, or from soldering the terminals again while installing!