Hi,
I have just finished putting together the kit. It passed the resistance check, however it did not pass the voltage check.
The top LED (the one connecting to A8 and center pin) fails to illuminate.
Finally, the 2 big white resistors get pretty hot. Is this normal behavior? Are these bleeder resistors?
Voltage readouts (VDC):
1: 150
2: 165
3: 0
4: 165
5: 82
6: 0
7: 150
8: 0
9: 106
10: 0
Thanks,
Hudson Green
EDIT: The voltage on A8 is around 13VDC. This is much higher than on A3, which is around 1.5VDC. Does this signify that the LED needs to be replaced? I assume the LED is supposed to act sort of like a pull down resistor. If so, what is the part number for it? Is it available on Mouser?