Hi,
I fininshed up two paramour IIs over the weekend and have a couple of voltage readings that are off.
There is some consistency however. Although the readings vary from the spec, the readings in the two paramours are the same. Makes me think there is something wrong with the spec.
Problematic readings are at
terminal/pin spec reading reading
amp1 amp2
P2 136 39 39
P3 130 39 39
A1 0.17 0.69 0.69
I should mention that all leds and tubes light up and all resistances were within spec
I am able to adjust the hum to 2.4 in one amp and 2.8 in the other.
Should I worry about these readings? If so, any ideas on where to start? Alternatively, has the manual been updated with new voltage values?
Thanks for any help.
Bob Musson
Bob Musson
Seduction (extended), Foreplay, Paramours, Klipsch Heresys, Orcas, Crack plus HD 600s
Lovin the Bottlehead sound in Maryland