Taping tubes

[adamct]

I have a tube cooler / damper that is basically just a long, thick solid copper tube to slip over signal tubes (e.g., 12AU7, 12BH7 or E80CC). On the inside of the tube damper there are little plastic

[johnsonad]

I'm trying to understand why you would want to do this? None of the tubes listed get very hot and you wouldn't need to assist in removing heat from them in a Bottlehead design which is open to air. What is your goal? To dampen the vibration to reduce a microphonic tube or remove heat?? 

[adamct]

Mostly dampen vibration. Beyond which...I like the way it looks! 

[Doc B.]

Copper tape will damp vibration somewhat, mostly at very high frequencies IIRC. It's not great, but it is visible on a scope. If you solder a drain wire to the tape and attach it to the chassis it will also work as somewhat of a shield for EMI.

[2wo]

How about, get some plumbers Teflon tape and wind a couple of rings on the tube till the dampener fits. Cheep and easy. Plus I have some success, using this stuff directly as a dampener, some success...John   

[adamct]

Excellent idea! The manufacturer of the tube damper actually produces a high temperature version of these that uses some sort of Teflon bumper. Thanks for the suggestion!