QUICKIE AC POWER SUPPLY

coca · 2977

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline coca

  • Full Member
  • ***
    • Posts: 141
on: May 19, 2014, 06:50:14 PM
Some time ago someone posted a schematic of an AC power supply for the QUICKIE. I have been trying to find it, but to no avail.I wonder if someone could display it again?
Thanks in avance,

Bernie.


Offline mcandmar

  • Hero Member
  • *****
    • Posts: 1599
  • Not all engineers are civil
Reply #1 on: May 20, 2014, 03:11:18 AM
I posted some details of my build, it was a little overkill to be honest so the design could be simplified.   In short you need ~38v for the plates, and 1.4v for the filaments.  The crucial bit is you need two fully independent (i.e. floating) 1.4v supplies for the filaments, as in the + and - cannot be connected to the 38v high voltage supply in any way.

http://bottlehead.com/smf/index.php?topic=5829.0
« Last Edit: December 11, 2014, 05:07:41 PM by mcandmar »

M.McCandless

Offline jodgey4

  • Newbie
  • *
    • Posts: 5
Reply #2 on: December 11, 2014, 05:02:27 PM
Anybody got the schematic? I could design my own... but that would require learning and work.


Offline mcandmar

  • Hero Member
  • *****
    • Posts: 1599
  • Not all engineers are civil
Reply #3 on: December 11, 2014, 05:10:49 PM
Fixed the link in my above post.  Not necessarily the best design but it should give you some inspiration at least.

M.McCandless

4krow

  • Guest
Reply #4 on: December 14, 2014, 10:30:02 AM
 I just recommended the Q in another forum. One reason was for the battery power. On the other hand, I would curious how an over the top AC power supply would perform.


Pages: 1   Go Up
« previous next »