Resistance check (terminals 6 & 10) [resolved]

jorgen83 · 1252

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline jorgen83

  • Newbie
  • *
    • Posts: 2
on: March 15, 2015, 03:05:24 AM
I just finished my build, and all resistances are correct, except for terminal 6 and 10, which both come up as 0 ohm instead of 2.4 K ohms.

I did connect the open terminals of the jack plug to ground, perhaps that gives different readings?
« Last Edit: March 15, 2015, 07:44:47 AM by Caucasian Blackplate »


Offline jorgen83

  • Newbie
  • *
    • Posts: 2
Reply #1 on: March 15, 2015, 03:17:00 AM
Ah yes, so I just found the answer. 6 and 10 are shorted to ground so 0 is correct :)


Pages: 1   Go Up
« previous next »