DC Filament Supply question [resolved]

d_composer · 1179

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline d_composer

  • Jr. Member
  • **
    • Posts: 36
on: November 02, 2017, 05:37:32 PM
I’m nearing the end of the DC Filament Supply mod install and I’m at the instruction to “attach and solder the twisted pair of wires formerly attached to 22L and 24L to the AC holes on the ciruit board closer to the A side” and then the other pair of wires go to the D side. What sides are these? I don’t see an A or D on the pcb. What side is this instruction referring to? Thanks!
« Last Edit: November 03, 2017, 05:25:26 AM by Caucasian Blackplate »


Offline fullheadofnothing

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 1487
  • A noble spirit embiggens the smallest man
Reply #1 on: November 02, 2017, 05:58:12 PM
Sockets. Same as in Stereomour manual.

Joshua Harris

I Write the Manuals That Make The Whole World Sing
Kit Packer Emeritus

Offline d_composer

  • Jr. Member
  • **
    • Posts: 36
Reply #2 on: November 03, 2017, 01:38:31 AM
Thanks! Built the Stereomour too long ago to remember the socket letter nomenclature!


Offline d_composer

  • Jr. Member
  • **
    • Posts: 36
Reply #3 on: November 03, 2017, 04:48:42 AM
Got it working - WOW!!!! Sounds amazing!!! ;D


Pages: 1   Go Up
« previous next »