Eros 2 Help 2

adeep42 · 2077

0 Members and 1 Guest are viewing this topic.

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19316
Reply #15 on: July 03, 2019, 07:04:14 AM
The one that's closer to the center of the long edge on the board, not the one by +reg.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man


Offline adeep42

  • Full Member
  • ***
    • Posts: 211
Reply #16 on: July 03, 2019, 07:11:53 AM
I don't see an X on that part of the board
.



Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19316
Reply #17 on: July 03, 2019, 07:12:52 AM
This?

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man


Offline adeep42

  • Full Member
  • ***
    • Posts: 211
Reply #18 on: July 03, 2019, 07:23:10 AM
Sorry, it was obscured by the cap.

2.48 vDC



Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19316
Reply #19 on: July 03, 2019, 07:26:40 AM
If you have 2.5V (2.48 is close enough) on that X terminal on the B side but Kreg is 0.6V on the same half of the board, you most likely have a miswire from the Kreg terminal to the D socket, or an ungrounded grid (D2 and D7 are the grids).

When you said before that you got "good readings" in your shunt regulator test, what were those readings exactly? 

You seem to have about the same problem you had previously.  It might be a good idea to go over the solder joints on the board above the D socket again.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man


Offline adeep42

  • Full Member
  • ***
    • Posts: 211
Reply #20 on: July 03, 2019, 08:15:15 AM
Hi Paul,

Think it's time to send this puppy to you.

Please advise.

Alan



Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19316
Reply #21 on: July 03, 2019, 09:42:26 AM

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man