Bottlehead Kits > Bottlehead Power Cord Kit
Continuity Question
(1/1)
Jimb0:
Tested the continuity but I'm getting 0.001 for all three pins
I set my voltometer to AC/2v like in the picture
Is this okay?
Doc B.:
That's the wrong end of the knob you're looking at. It's pointing to the continuity setting in the ohms scales at about 7:30 rather than the 2VAC scale at 1:30. If you don't have a continuity beeper on your meter you can just use your lowest ohms scale.
Jimb0:
perfect thanks Doc! I got 0.3 ohms for each reading
Doc B.:
Sounds like you're good to go.
Navigation
[0] Message Index
Go to full version