Trim pot question

oguinn · 574

0 Members and 1 Guest are viewing this topic.

Offline oguinn

  • Sr. Member
  • ****
    • Posts: 895
on: May 20, 2020, 09:37:58 AM
Trimming of the lead notwithstanding, does this look like a properly installed trim pot? This is the A side and the bent over lead is under the screw.

Jameson O'Guinn

-

Main System: Schiit Bifrost MB, Rega Planar 6 with Exact cartridge, Eros 2, BeePre, Kaiju/Stereomour II, Jagers, Mainline

Desktop System: Crack with Speedball


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19316
Reply #1 on: May 20, 2020, 10:04:19 AM
I don't see any issues.  Even if you bend the middle lead to the wrong side and solder it down, the amp will still work 100% properly, you'll just have to adjust the trim pot the other way to get the desired result when setting the bias.

-PB

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man


Offline oguinn

  • Sr. Member
  • ****
    • Posts: 895
Reply #2 on: May 20, 2020, 10:05:14 AM
Cool, thank you. Mostly wanted to make sure I interpreted the instructions correctly.

Jameson O'Guinn

-

Main System: Schiit Bifrost MB, Rega Planar 6 with Exact cartridge, Eros 2, BeePre, Kaiju/Stereomour II, Jagers, Mainline

Desktop System: Crack with Speedball