Resistance Question

[sharktopus]

I just finished assembling my new SEX amp and there are a few of my resistance readings I want to check with you all before proceeding to the voltage tests.  On terminals 30,31, & 32 I get 215 ohms.  And on terminals H2, H4, H5, & H7 I get 214 ohms.  Is that ok, or did I screw something up?  Also, I got to the end and had six 100K ohm resistors left over that I didn't see any place for.  Am I getting these numbers because those were supposed to be installed somewhere?

[Paul Birkeland]

215 ohms isn't a problem.  Some meters can resolve those resistances better than others. 

Can you pop up a photo of the 100K resistors?  My guess is that those got swept into your kit by mistake.

[sharktopus]

Sure, here you go.

[Paul Birkeland]

That's really odd, that doesn't look to be a part we even keep in the inventory. 

[Darkblade48]

Just as a followup; the manual doesn't seem to even indicate resistances for the aforementioned terminals (they just have an asterisk next to them); as long as the meter measures a non-zero value, will this be OK?

[Paul Birkeland]

Yes, something really low is a problem.   Anything else is OK.