Bottlehead Kits > Stereomour II

Headphone Jack

(1/2) > >>

acrockett55:
I am very interested in upgrading from the S.E.X 3.0 to the Stereomour II but one of my favorite features about the S.E.X. 3.0 is the built in headphone jack. Is this a possible upgrade or hack? Anyone done this before.

oguinn:
People have discussed it before, although not as a dedicated jack.

https://forum.bottlehead.com/index.php?topic=12776.0

peterq:
I made a pair of converter about speaker output, and found this page is really helpful.
https://robrobinette.com/HeadphoneResistorNetworkCalculator.htm

Paul Joppa:
There's no obvious place to put a headphone jack, but some have made an adapter for the speaker outputs. Check this link:

https://bottlehead.com/bottlehead-blog/

If your phones are sensitive, you may need the DC filament upgrade kit to keep the hum down.

Karl5150:
As Paul suggested, I followed Josh's blog post and my DT 770 PRO, 250 Ohm cans are dead quiet until the needle drop on my SMII with the DC filament upgrade. (Haven't tried my Drop HE4xx planers yet)
I tried the same cable/can combo on my Seductor amp, and while it worked I didn't spend enough time to form an opinion on sonics.
Karl 

Navigation

[0] Message Index

[#] Next page