BeePre mono input...

bernieclub · 804

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline bernieclub

  • Full Member
  • ***
    • Posts: 114
on: April 27, 2021, 01:53:34 AM
I'd like to get a mono input to both channels to do some output capacitor comparisons and I'm having trouble getting my source to output mono.   Can I simply jumper the center pins of the input jacks?  I have some V-Cap ODAMs in anticipation of upgrades and I'd like to give them a semi valid taste test.   Thanks!
Bernie

Bernie Zitomer

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19353
Reply #1 on: April 27, 2021, 04:48:20 AM
If this is BeePre 2, I would jumper the outputs of the balance pots.  If it's the BeePre 1, I would jumper the outputs of the volume pot.  Doing this will provide some impedance between the outputs of your sources that may be desirable.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline bernieclub

  • Full Member
  • ***
    • Posts: 114
Reply #2 on: April 27, 2021, 07:50:06 AM
Thanks P.B., it's BP2...I'll jumper the balance pot.

Bernie Zitomer

Pages: 1   Go Up
« previous next »