Left channel RCA jack not passing resistance check

Shackney1127 · 476

0 Members and 1 Guest are viewing this topic.

Offline Shackney1127

  • Jr. Member
  • **
    • Posts: 13
on: August 02, 2022, 10:33:57 AM
Finished building the Crack. Did resistance checks. Only thing that doesn't pass is the left rca jack. I get no resistance. My multimeter actually beeps sometimes. To my knowledge, this indicates a short. Any tips or advice?

Thanks!



Offline Doc B.

  • Administrator
  • Hero Member
  • *****
    • Posts: 9538
    • Bottlehead
Reply #1 on: August 02, 2022, 12:51:31 PM
The most common issue is a solder bridge between the outer shell and the center pin of the jack.

Dan "Doc B." Schmalle
President For Life
Bottlehead Corp.


Offline Shackney1127

  • Jr. Member
  • **
    • Posts: 13
Reply #2 on: August 03, 2022, 01:15:59 PM
That looks like the case. Tried removing as much as I could with solder wick, but no dice. Guess I'll just order a replacement and try again.



Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19316
Reply #3 on: August 03, 2022, 04:58:24 PM
You can also cut the solder off with side cutters or use a small flat head screwdriver to scrape it away.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man