September 28, 2023, 05:15:48 PM

Author Topic: Another Voltage Issue  (Read 785 times)

0 Members and 1 Guest are viewing this topic.

Offline johnphirsch

  • Newbie
  • *
  • Posts: 3
Another Voltage Issue
« on: November 15, 2022, 12:36:37 PM »
Hi All,

I'm just completing a stereomour 2. The resistance check went fine, but I ran into an issue with the voltage check. #14 was a zero instead of 170-230vdc. I also have a led light out in position d1b (I believe). I've looked around, but am not seeing anything that jumps out at me, but then again this is my first build. Thanks for any help available.


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 18679
Re: Another Voltage Issue
« Reply #1 on: November 15, 2022, 02:14:48 PM »
Other than the LEDS, you need to heat the solder joints on that PC board until the solder flows through the board to the other side.  Do not apply solder to the other side though, just let what's on the bottom flow through to the other side.
Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man