Driver Testing Error [resolved]

blackharp · 1911

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline blackharp

  • Jr. Member
  • **
    • Posts: 41
on: May 06, 2023, 06:43:04 AM
On page 65, IA & IO measure correctly, but at 32U I get 136VDC and the potentiometer on the board does not affect the reading. I turn and it remains. On 46U, I was able to adjust the pot to 175VDC. Any ideas?
« Last Edit: May 06, 2023, 11:57:13 AM by Paul Birkeland »


Offline blackharp

  • Jr. Member
  • **
    • Posts: 41
Reply #1 on: May 06, 2023, 07:41:03 AM
Photo


Offline Lowercase

  • Jr. Member
  • **
    • Posts: 46
Reply #2 on: May 06, 2023, 08:25:50 AM
Looks like you are missing the 4.99KΩ 1⁄8W resistor in the R3 position on the A side of the board. Last step on page 56. That should resolve it.

Also noticed some of the joints might need a bit more solder too.
« Last Edit: May 06, 2023, 08:42:54 AM by Lowercase »


Offline blackharp

  • Jr. Member
  • **
    • Posts: 41
Reply #3 on: May 06, 2023, 09:48:17 AM
Thank you!! That worked.


Pages: 1   Go Up
« previous next »