Bottlehead Kits > BeePre
Resistance check is 0
(1/1)
hpleung:
I am doing my first resistance check with the beepree.
The terminal 8 vs terminal 1 is yielding 0; like it is not connected.
Is there any pointers on where i should look?
Note: terminal 8 and terminal 16 yield 4.5 ohm.
hpleung:
Attached pic
Paul Birkeland:
See the second to the last step on page 35 of the manual. Also be sure you didn't accidentally do the same thing on the other side.
hpleung:
Thank you that was it. I have a generic question.
The instruction says go terminal 8 then 9.
Electrically if you went to 9 then 8; does it make a difference?
Similarly, if the instruction says connect to L and you connect to U; does that make a difference
Of course i am following the instructions to the letter but i wanted to know if it makes a differences.
Paul Birkeland:
That doesn't make a difference electrically.
Navigation
[0] Message Index
Go to full version