Bottlehead Kits > BeePre
More resistance check
(1/1)
hpleung:
Almost all resistance checks completed.
However
Terminal 8 to Terminal 10 measured 0L for me. It is supposed to measure 20K ohm
Similarly Terminal 8 to Terminal 15 measures 0L. It is also supposed to measure 20k ohm.
I dont see any “start low and riseâ€; it stays 0L which seems to indicate i am missing a wire.
Any pointer on where i should look?
Paul Birkeland:
There's a cap there, you're looking for a reading of 20K+ Ohms, which is what you have.
hpleung:
Thank you.
Navigation
[0] Message Index
Go to full version