Paramount DC Heaters

AudioDave · 3351

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline AudioDave

  • Full Member
  • ***
    • Posts: 106
on: February 16, 2011, 03:42:21 PM
I am confused (and probably a little slow), so my apologies if this has been covered previously but I can't seem to find anything in the archives.  From what I can gather, am I correct in that the Paramount power tubes (300B or 2A3) have DC filiments?  What about the driver tubes in the upgraded Paramount, are they DC and if not would this be a good mod?
Thanks!
Dave 


Online Paul Joppa

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 5830
Reply #1 on: February 16, 2011, 04:37:46 PM
The Paramount has DC filament power for the 2A3 or 300B. The power supply is filtered with a split (symmetrical) choke - we think this sounds better than regulators or capacitors.

The driver is AC heated; the winding is grounded at the center tap to eliminate common-mode induced hum but is not DC. Converting to a DC heater supply for the driver would be a good modification.

Paul Joppa

Offline AudioDave

  • Full Member
  • ***
    • Posts: 106
Reply #2 on: February 16, 2011, 04:41:48 PM
Excellent,  Thank You Paul!


Pages: 1   Go Up
« previous next »