Bottlehead Kits > Bottlehead Power Cord Kit
Design intent
johnjen:
I just ordered a second cable kit and a question occurs to me to ask about a construction detail. Namely why are the wires only stripped to 1/4"?
In my time as a tech when I'd make up power cables I was under the impression that a larger contact patch between the wires and the metal that pinched them was a desirable thing. Is there a sonic (or other) reason for staying with 1/4"?
Just wondering.
JJ
Doc B.:
I don't want noobs leaving too much wire bare and shorting out the connections. But of course you can do it however you like.
johnjen:
Thanks for the reply.
Yeah I can see where stray strands could light up their life, at least for a very brief moment. :D
I think I'm going to go back in and re-terminate, just to see if I can hear any difference
johnjen:
Yeah I re-terminated the 'old' cable and made sure it had as big a contact patch as possible given the existing parts.
I can't say I'm hearing any difference from this one change. But then I've been making a bunch of changes and the overall effect is improvement across the board.
But the initial addition of the cable DID make a noticeable difference.
JJ :thumb
najo49:
Thanks Doc, for yet another blast to the Newbie.I am starting a forum to bring newbie right to alls attention.I for example know that striping a wire 1/4 or 3/8 is never going to change the sound on anything. Please see my post on graduation.I now bow to the west,i am in wyo. and prostrate myself 1/4 to 3/8 times.Jann o.
Navigation
[0] Message Index
[#] Next page
Go to full version