Crack Voltage off, Front LED flickers

hanar · 1281

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline hanar

  • Newbie
  • *
    • Posts: 4
on: December 13, 2012, 09:51:16 AM
Well my resistance checks seem to be within 10%, but a few of my voltage readings are off. A-1 is 0, terminal 5 is 86 volts, B-4 is 0, and B6 is 70 volts.  The strange thing is that, while grounded at B12, the front led lights up when I touch B5 with the positive wand of the meter.  The rear led is always on.  Probably a bad solder.  Ideas?


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19365
Reply #1 on: December 13, 2012, 10:49:57 AM
What is terminal 2 and 3?  Looks like a short in the wiring on the 9 pin or octal socket.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline hanar

  • Newbie
  • *
    • Posts: 4
Reply #2 on: December 13, 2012, 10:53:31 AM
I'll have to go back and measure 2,3 again.  I only wrote down the ones that were over 10% off.  But I'll definitely check out your suggestions.  Thanks.


Pages: 1   Go Up
« previous next »