Hum

tsingle999 · 2710

« previous next »
Pages: 1   Go Down

0 Members and 2 Guests are viewing this topic.

Offline tsingle999

  • Sr. Member
  • ****
    • Posts: 275
  • We are all here because we are not all there.
on: May 13, 2013, 07:05:35 AM
I have a hum that seems to follow the 45 tube. Its louder than normal hum. Is it a bad tube?

SGC iTransporter with Qobuz & Roon to SIg Optical Rendu to BH DAC (Battery) / Wavelegth Crimson to BeePre to 300b(ehemoths) to Cain & Cain & Blumenstein Double Horn IM Ben
Bottlehead Stat headphone amp

Offline galyons

  • Sr. Member
  • ****
    • Posts: 626
  • Geary Lyons
Reply #1 on: May 13, 2013, 08:09:09 AM
Quote from: tsingle999 on May 13, 2013, 07:05:35 AM
...hum that seems to follow the 45 tube.

Sadly, most likely it is the tube!
Cheers,
Geary

VPI TNT IV/JMW 3D 12+Benz LP-S>  Eros + Auralic Aries + ANK Dac 4.1 >Eros TH+ Otari MX5050 IIIB2 > BeePre >Paramount 300B 7N7 > EV Sentry IV-A

Thorens TD124/Ortofon RMG-212/SPU >Seduction > Smash^Up> Paramour 45 MQ >K12's

Offline Paul Joppa

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 5894
Reply #2 on: May 13, 2013, 09:38:47 AM
The hum pot exists because tubes vary from one to another. But if you cannot get rid of the hum with the hum pot, then it's most likely the tube.

Paul Joppa

Offline tsingle999

  • Sr. Member
  • ****
    • Posts: 275
  • We are all here because we are not all there.
Reply #3 on: May 13, 2013, 10:14:07 AM
Ouch! The hum pot doesn't affect it. Ok thanks guys!
Its a Vaic vv45. Theres no issues using it with the sr45?
Filament voltage 2.5, filament current 7.35 amps, grid voltage 42
Ug and gm tested at ia 50 ma and ua 280 volts..
« Last Edit: May 13, 2013, 10:22:00 AM by tsingle999 »

SGC iTransporter with Qobuz & Roon to SIg Optical Rendu to BH DAC (Battery) / Wavelegth Crimson to BeePre to 300b(ehemoths) to Cain & Cain & Blumenstein Double Horn IM Ben
Bottlehead Stat headphone amp

Offline Paul Joppa

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 5894
Reply #4 on: May 13, 2013, 11:05:07 AM
Hope that 7.35 amps is a typo! Should not be any issues, except to check that the power line voltage is close to 120v.

Paul Joppa

Pages: 1   Go Up
« previous next »