Tantalum resistors

johnsonad · 1313

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline johnsonad

  • Hero Member
  • *****
    • Posts: 1670
on: September 08, 2013, 10:14:30 AM
Are there any places in the SEX that could potentially benefit from a tantalum resistor upgrade?  If so, specifically which resistors would benefit?

Are there any other types and locations which would benifit from an upgrade to achieve a slightly better sound?

Aaron Johnson

Offline Jim R.

  • Hero Member
  • *****
    • Posts: 2194
  • Blind Bottlehead
Reply #1 on: September 08, 2013, 10:22:03 AM
Aaron,

Typically best place for them is plate loads but you have the c4s on the drivers and plate chokes on the power sections, but the current setting resistor on the c4s is a good place for these. Not sure I'd want to use them for bias resistors, but I guess it can't hurt to try.

HTH,

Jim

Jim Rebman -- recovering audiophile

Equitech balanced power; uRendu, USB processor -> Musette DAC -> 5670 tube buffer -> Finale Audio F138 FFX -> Cain and Cain Abbys near-field).

s.e.x. 2.1 under construction.  Want list: Stereomour II

All ICs homemade (speaker and power next)

Pages: 1   Go Up
« previous next »