lost a channel with integration [solved]

pjnestor · 2974

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline pjnestor

  • Jr. Member
  • **
    • Posts: 25
on: January 18, 2014, 11:28:00 AM
Hi,

I am working on the integration upgrade.  Had no problem with the shunt regulator, but on the B side C4S board, I have 0 volts at terminal 31 and the diodes do not light up on that side.  The A side lights up fine.  I've double checked the board and connections, but don't see any obvious mistakes.  Any suggestions where to look.

Pat
« Last Edit: January 23, 2014, 06:28:15 PM by Caucasian Blackplate »


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19353
Reply #1 on: January 18, 2014, 12:45:54 PM
Generally this is an issue with the center leg of the MJE-350 not being heated up enough during soldering.

-PB

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline pjnestor

  • Jr. Member
  • **
    • Posts: 25
Reply #2 on: January 23, 2014, 05:17:17 PM
Thanks paul, that did the trick.  Sounds great


Pages: 1   Go Up
« previous next »