IMO the first step of the manual should be......

John EH · 1727

0 Members and 2 Guests are viewing this topic.

Offline John EH

  • Sr. Member
  • ****
    • Posts: 358
on: November 22, 2014, 01:51:10 PM
Don't install the terminal strip on the 9 pin socket and do the LED's first.  Then install the terminal strip, then go to step 1.

You will thank me for this.  It is SO much easier to solder the LED's with nothing in the way.

« Last Edit: November 22, 2014, 03:22:05 PM by John EH »



Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19694
Reply #1 on: November 23, 2014, 11:08:36 AM
Yeah, that splits up "put the hardware on" with "solder parts on".

A good set of long nose needle nose pliers makes this task a lot easier.

-PB

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man


Offline John EH

  • Sr. Member
  • ****
    • Posts: 358
Reply #2 on: November 23, 2014, 12:50:38 PM
Yeah, that splits up "put the hardware on" with "solder parts on".

A good set of long nose needle nose pliers makes this task a lot easier.

-PB

agreed it messes with the flow of the manual, but from a pure builders standpoint it sure is one heck of a lot easier.  I understand why the manual is written as it is.