Bottlehead Kits > Crack-a-two-a

Tube Rolling

(1/12) > >>

TurbOSquiD77:
Hello everyone and happy holiday!

Starting my Crackatwoa build today. Can I roll these tubes? I did in the Crack but just wanted to double check for use with it's big brother.

Svetlana 6AS7G/6H13C "Winged C"
Philips Miniwatt ECC82 made in Heerlen , Holland, 1962.

https://i.imgur.com/2RWRxxZ.jpg
https://i.imgur.com/SjBE6OD.jpg


Any suggestions you think would be fun to try with the shunt voltage reg. tubes?

Cheers!  ;D

Paul Birkeland:
The allowable tubes are identical between the Crack and Crack-a-two-a.

For the shunt reg tubes, I tend to use 6005's.

kritpoon:

--- Quote from: Caucasian Blackplate on November 26, 2016, 12:53:41 PM ---The allowable tubes are identical between the Crack and Crack-a-two-a.

For the shunt reg tubes, I tend to use 6005's.

--- End quote ---

For rolling the Shunt reg tube, would the effect of the overall sound be as pronounce as rolling the input and power tube? Thank you

Krit.

Doc B.:
In general rolling the shunt reg tube is audible but much more subtle than rolling the signal tubes. Probably something best tried for yourself rather than relying upon opinions.

kritpoon:

--- Quote from: Doc B. on December 19, 2016, 06:31:12 AM ---In general rolling the shunt reg tube is audible but much more subtle than rolling the signal tubes. Probably something best tried for yourself rather than relying upon opinions.

--- End quote ---

Thanks Doc. I don' have crackatwoa yet, just gathering some info. Since its on my next to purchase list, after I experiment on mod on my Crack to see how each mod effects the sound. I am lerning so much and its so much fun! I am proud to say that I am bottlehead addict now.

Navigation

[0] Message Index

[#] Next page