Bottlehead Crack 1.1 OTL Does it pan? [resolved]

jlaba92 · 1141

« previous next »
Pages: 1 2   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19406
Reply #15 on: April 06, 2021, 10:46:00 AM
On page 20 of the manual in bright red letters we provide instructions on what we mean when we say "attach".  This has not been done with your kit, and I would suggest revisiting the manual and reading that short paragraph, then going over your kit and implementing those recommendations.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline jlaba92

  • Jr. Member
  • **
    • Posts: 10
Reply #16 on: April 06, 2021, 10:57:24 AM
When you say this has not been done with my kit, what area are you referencing to? I did not solder until explicitly told by the manual to do so as far as i know.


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19406
Reply #17 on: April 06, 2021, 11:22:11 AM
And the sentence before that one...

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline jlaba92

  • Jr. Member
  • **
    • Posts: 10
Reply #18 on: April 07, 2021, 07:55:47 AM
Thank you for the tip, I will go back and recheck everything.


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19406
Reply #19 on: April 07, 2021, 09:46:48 AM
You need to attach all the components to the terminals.  None of your connections are attached, they just pass through the terminals.  This is going to make your build more unreliable than it would otherwise be.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline jlaba92

  • Jr. Member
  • **
    • Posts: 10
Reply #20 on: April 13, 2021, 10:42:52 AM
Just got stereo to work. I have no clue what I did, but it works now.


Pages: 1 2   Go Up
« previous next »