Bottlehead Kits > Kaiju Stereo 300B amp

end bells on plate chokes

<< < (2/2)

braubeat:
you can buy a cover to put over the entire transformer, but you must take into consideration the extra heat buildup if the units run hot

Michael

Jeroen:
Thanks for the advice, I will leave the channel frame on it's place.

What about attach end bells with some glue to the channel frame? That won't hurd I guess..

What size end bells do I need?


Regards Jeroen

Paul Joppa:
The Kaiju plate choke and output transformer core laminations are 2.5" high and 3.0" wide, so that will be the available end bell size. The channel frame is a bit larger since it fits around the lams. So, there will be a small stair-step around the edges. I don't know whether it's possible or not to trim the end bell edges to just fit within the channel frame edges.

Note that some end bells fold over the core a bit; obviously those will NOT fit - check the specs carefully!

Navigation

[0] Message Index

[*] Previous page