Smoked Resistor

Cary · 10110

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Cary

  • Full Member
  • ***
    • Posts: 219
on: September 09, 2019, 12:42:13 PM
Hi Dan and Paul,

After I did the resistance checks, which were correct, I plugged in the amp, the 3.32K, 1/2 watt, resistor on points 45 and 47 began to smoke. I double checked my wiring and everything is correct, any ideals what went wrong?

Thank you,

Cary


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19744
Reply #1 on: September 09, 2019, 02:35:37 PM
I would post some build photos, maybe we can spot something. 

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19744
Reply #2 on: September 09, 2019, 06:12:12 PM
Also triple check the orientation of the 22uF cap that follows that part.  If it's in backwards, the 3.32K resistor will smoke.  If one end of the 3.32K resistor is connected to an incorrect terminal, it could also smoke.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Cary

  • Full Member
  • ***
    • Posts: 219
Reply #3 on: September 11, 2019, 12:51:45 PM
Hi Paul,

I triple checked the orientation of the 22uF caps, everything was correct, what is my next step?

Cary


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19744
Reply #4 on: September 11, 2019, 12:52:28 PM
Post some photos.

-PB

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Pages: 1   Go Up
« previous next »