931 Ohm resistor size paranoia

Thermioniclife · 1226

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Thermioniclife

  • Sr. Member
  • ****
    • Posts: 794
on: September 19, 2019, 05:02:54 PM
Hello All,
I got my BeePre kit yesterday and will receive my Crack and Speedball next week ,Yeah!
I'm a little paranoid regarding the body size of the 931 Ohm resistor on the filament regulator board.
It looks more like a 1/4w than a 1/2 w. I'm sure I am wrong, as I often am.
Please see the pic and tell me everything is going to be alright. Ok.
Thanks,
Lee

Lee R.

Offline grufti

  • Sr. Member
  • ****
    • Posts: 320
Reply #1 on: September 19, 2019, 06:12:45 PM
You're good for that Rset2 resistor. It doesn't look like the one in the BeePre manual, but it is 1/2W


Offline Doc B.

  • Administrator
  • Hero Member
  • *****
    • Posts: 9657
    • Bottlehead
Reply #2 on: September 19, 2019, 06:30:02 PM
That resistor dissipates less than 0.1 watts.

Dan "Doc B." Schmalle
President For Life
Bottlehead Corp.

Offline Thermioniclife

  • Sr. Member
  • ****
    • Posts: 794
Reply #3 on: September 19, 2019, 06:57:13 PM
Thanks Doc,
Was worried that the bom called for a 1/2w.
By the way, I knew you were into Seduction, Foreplay, Paramours, and Sex, But now Crack, Speedballs, and Nitrous Oxide at
Bonneville! You sir have a problem, a problem I wish I had!
Best wishes,
Lee

Lee R.

Pages: 1   Go Up
« previous next »