Just got the kit assembled and it passes most resistance check except one - I've got 7.6 ohm - 80 ohm over several re-test (after referring to an old thread where gbennn got 'infinity' on 22, I've since checked through the ground lug, RCA jacks and did some touch up) here's the current measurements I've got:
1. *
2. *
3. 0.6 (my cheap multimeter won't got any lower than that, even with red and black pins touching each other directly 0.6 is the lowest possible)
4. *
5. *
6. 0.6
7. 2.96k
8. 0.6
9. 2.96k
10. 0.6
12. 0.6
13. *
14. 0.6
20. 0.6
22. 15.6 << abnormal
B3. 2.96k
B6. 2.96k
RCA
L - ~100k
R - ~97k
GRN - 0.6
* I have initially painted both side of the transformer bell (was rather careless for not reading through the manual before that), but have since scrapped off the 4 corners where washers are placed, pretty sure it has got clean contact to the bell.
Any pointer to check is very much appreciated, thanks!
