failed High Voltage Power Test [resolved]

Dynakitbuilder · 5497

« previous next »
Pages: 1 2 3   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19750
Reply #30 on: March 02, 2021, 11:23:42 AM
Can you check the DC voltage between 34 and 36?

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Dynakitbuilder

  • Jr. Member
  • **
    • Posts: 49
Reply #31 on: March 02, 2021, 11:41:07 AM
260.5 VDC between  34 & 36


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19750
Reply #32 on: March 02, 2021, 11:58:56 AM
OK, you can put the resistor back at 31.  If the fuse blows for some reason after you do this, please post lots of photos of the area around terminal 31.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Dynakitbuilder

  • Jr. Member
  • **
    • Posts: 49
Reply #33 on: March 03, 2021, 04:13:15 AM
Final VDC readings at 33-31: 260 VDC +/-.  Passed! OK, what did you and I learn from going through the successive tests and detaching reattaching the resistors?  That the problem was in my soldering?   Thanks very much for your patience and perserverence.  OK to continue building the kit now?


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19750
Reply #34 on: March 03, 2021, 05:40:38 AM
Yes, you're good to go.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Pages: 1 2 3   Go Up
« previous next »