Choke - Under Chassis Position

Ken · 1417

0 Members and 2 Guests are viewing this topic.

Offline Ken

  • Full Member
  • ***
    • Posts: 58
on: February 15, 2023, 11:24:50 AM
I'm continuing to work on the rebirth of my Afterglows and I would like to move them onto a slightly larger chassis plate.  I'm considering various dimensions and resulting layout options.

If one were to suspend the choke under the chassis, is there an optimal position and/or least desirable position relative to the other components, especially the transformers?

"It is not that I am mad; it is just that my head is different from yours" - Diogenes of Sinope


Offline Paul Joppa

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 5822
Reply #1 on: February 15, 2023, 11:39:57 AM
The choke is not too critical, just keep it not too near the output transformer. The OPT is critical, keep its position and orientation relative to the power transformer as in the manual.

I'll just note that the further you deviate from the manual, the less we'll be able to help out.

Paul Joppa


Offline Ken

  • Full Member
  • ***
    • Posts: 58
Reply #2 on: February 15, 2023, 01:13:42 PM
Thanks Paul.  Understood.  I won't be deviating at all from the circuit itself, except as advised by you and PB.  In terms of physical layout, other than possibly relocating the choke under the chassis,  I only plan to move the binding posts and the fused IEC receptacle off the chassis plate.

"It is not that I am mad; it is just that my head is different from yours" - Diogenes of Sinope


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19694
Reply #3 on: February 15, 2023, 01:23:12 PM
The cathode bias resistor needs to be changed out to a higher wattage part for longevity.  Accomplishing that will require mostly a new layout. 

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man


Offline Ken

  • Full Member
  • ***
    • Posts: 58
Reply #4 on: February 15, 2023, 02:13:43 PM
Thanks Paul.  Yes, I have that upgraded cathode resistor on my parts list from your previous email.  When I actually have the larger components in hand I can get serious about the layout.

I am leaning towards a 20cm x 25cm chassis in portrait rather than landscape orientation.  Hence the choke would not fit in the usual above board place beside the power transformer.

"It is not that I am mad; it is just that my head is different from yours" - Diogenes of Sinope