Wiring question for Crack

mike_b · 1659

0 Members and 1 Guest are viewing this topic.

Offline mike_b

  • Newbie
  • *
    • Posts: 9
on: January 07, 2014, 09:13:39 AM
Can I use 20awg solid, 300V, 80 degree C, as a substitute for the Carol 600V hookup wire that came with the kit from the RCA inputs to a Valab 23-step attenuator? Can't find the Carol wire locally without having to buy it by the 100 ft. roll $$$.

Thanks
 
mike_b 

Mike B.
Laid Back with Crack and that's a fact, Jack!


Offline galyons

  • Sr. Member
  • ****
    • Posts: 626
  • Geary Lyons
Reply #1 on: January 07, 2014, 09:31:17 AM
Yes, there is very little voltage in that path.  Over all the voltages in the Crack don't exceed 206v +/- 15%, and that is only at terminal 21 directly off of the power tranny.  Quality wise, depends on your feelings about wire.  The Carol is good, but I used 20 gauge, mil-spec silver plated OFC with teflon for that run.

Cheers,
Geary

VPI TNT IV/JMW 3D 12+Benz LP-S>  Eros + Auralic Aries + ANK Dac 4.1 >Eros TH+ Otari MX5050 IIIB2 > BeePre >Paramount 300B 7N7 > EV Sentry IV-A

Thorens TD124/Ortofon RMG-212/SPU >Seduction > Smash^Up> Paramour 45 MQ >K12's