How to wire a Goldpoint volume control

[sbelyo]

So I'm at the top of page 25 on the third step

( ) Attach the red wire at the free end of the
cable to the center terminal of the lower set
of terminals ( that is, closest to the chassis
plate) on the volume potentiometer. Solder
this connection

This is the right output of the volume control correct?

And the seventh step

( ) Attach the red wire of the 3/4” end to the lower terminal of the potentiometer that is nearest the
headphone jack. Solder this connection.

This is the right input of the volume control correct?

[mcandmar]

Sounds right to me, just make sure you keep the shield connections the same, i.e. shield from both cables join together and terminate at point 13 & 23.

[sbelyo]

got it...  i had to read it a few times to make sure

[sbelyo]

got the right wired up no problem.  The length of wire mentioned in the directions will work just fine.  No need to adjust.

[sbelyo]

got the left wired up.  I would add 1/2" to the lengths of wire for the first and fifth step on page 26.  Since the goldpoint control is taller you might need the extra bit of length.

[sbelyo]

Here's a pic