Noise on one channel with certain kinds of music only

Al Campone · 1383

0 Members and 1 Guest are viewing this topic.

Offline Al Campone

  • Newbie
  • *
    • Posts: 3
Help!!

I finished assembling my bottlehead crack some weeks ago and had a couple of really wonderful hours listening to my music -- until.... I stumbled over one song where some (yes: a faint CRACKle) noise occurs.

The noise is reproducable, but occurs only during certain, rather loud passages of the song. It is a rather ambient song (Lustmord: Babel); I exchanged the main tube without effect and resoldered (as good as I could) - also without effect. The noise is not in the song itself (tried with the same headphone on a different amp).

Is there somebody with a similar problem?

Would it help to install the speedball upgrade or would this just increase the complexity of the problem?

Thanks a lot for any helpful comments...

BW










Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19757
Reply #1 on: March 26, 2015, 11:15:19 AM
This is almost certainly a flaky solder joint, I would go over them very carefully with your iron, being sure that they are all flowed and tight.

-PB

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man


Offline Al Campone

  • Newbie
  • *
    • Posts: 3
Reply #2 on: March 26, 2015, 11:18:16 AM
I just did that... but maybe not thorougly enough... is there a part of the circuit that is more likely to produce this kind of problem?

Thx!!
C



Online Doc B.

  • Administrator
  • Hero Member
  • *****
    • Posts: 9659
    • Bottlehead
Reply #3 on: March 26, 2015, 11:35:31 AM
Loud passage, just one song - you're probably just clipping the amp.

Dan "Doc B." Schmalle
President For Life
Bottlehead Corp.


Offline Al Campone

  • Newbie
  • *
    • Posts: 3
Reply #4 on: March 26, 2015, 12:15:55 PM
Hm.... I don't think so because the noise seems somehow decoupled from the music. I would expect that clipping rather produces a distortion of the music itself?

Will check if the noise vanishes with lower input or output levels and if it makes a difference if input channels are exchanged...