How to identify output transformer wiring

gsharri · 13356

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline gsharri

  • Newbie
  • *
    • Posts: 6
on: September 03, 2022, 01:54:47 PM
I recently purchased a pair of Paramount 300b amps. I am not sure how the output transformers are wired (4,8, or 16 ohms). Is there a manual or diagram available?
Thanks
Scott


Offline Paul Joppa

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 5830
Reply #1 on: September 03, 2022, 06:00:28 PM
Yes, there is a short (one page) document on that transformer. I have attached it in PDF form. It shows the wiring for a 4-8-16 ohm switch using a 2-pole 3-throw switch.

Paul Joppa

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19744
Reply #2 on: September 03, 2022, 06:29:03 PM
This is the most likely configuration.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline gsharri

  • Newbie
  • *
    • Posts: 6
Reply #3 on: September 06, 2022, 08:05:15 AM
Thank you both!
I purchased these from Gig Harbor Audio last week. Erik, there, told me they had been "modified by Paul at the factory" but didn't say when that occurred. Would that be one of you?
Scott


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19744
Reply #4 on: September 06, 2022, 08:35:43 AM
Yes, I changed them to use the 6LU8 after using them for a few years. 

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Pages: 1   Go Up
« previous next »