Resistance check is 0

[hpleung]

I am doing my first resistance check with the beepree.

The terminal 8 vs terminal 1 is yielding 0; like it is not connected.

Is there any pointers on where i should look?

Note: terminal 8 and terminal 16 yield 4.5 ohm.

[hpleung]

Attached pic

[Paul Birkeland]

See the second to the last step on page 35 of the manual.  Also be sure you didn't accidentally do the same thing on the other side.

[hpleung]

Thank you that was it. I have a generic question.

The instruction says go terminal 8 then 9.

Electrically if you went to 9 then 8; does it make a difference?

Similarly, if the instruction says connect to L and you connect to U; does that make a difference

Of course i am following the instructions to the letter but i wanted to know if it makes a differences.

[Paul Birkeland]

That doesn't make a difference electrically.