Swamping resistor

proud indian · 4628

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline proud indian

  • Full Member
  • ***
    • Posts: 159
on: July 06, 2017, 03:48:21 AM
My pm6a lowthers could do with a 47 ohm resistor put across the speaker terminals as per lowther America.  Rather than open up the spealers, can I just put it at the amp end on the speaker posts? My speaker cabinets do not have binding posts and i run them direct from the amp. Would I get the same resluts for testing?

Thanks,

Shreekant

system 1. oppo, quickie,SEX 2.1 ( V cap), Decware DFR8 in ZOB cabs
System 2. Tascam cd200, Terra Dac,Zbox,Decware Zen amp(V cap) Lowther PM6A in Acousta horns.
Maple rack, Brass footers,Power conditioner, dedicated treated room, iso pads, plenty of tubes. All cables DIY.

Offline Doc B.

  • Administrator
  • Hero Member
  • *****
    • Posts: 9670
    • Bottlehead
Reply #1 on: July 06, 2017, 05:33:50 AM
It's slightly better in theory to have the resistor closer to the driver, but it will work fine.

Dan "Doc B." Schmalle
President For Life
Bottlehead Corp.

Offline proud indian

  • Full Member
  • ***
    • Posts: 159
Reply #2 on: July 06, 2017, 05:45:10 AM
Thanks. So I can put in now, without blowing up the amp, and then do it at the speaker end during the  weekend..

Shreekant

system 1. oppo, quickie,SEX 2.1 ( V cap), Decware DFR8 in ZOB cabs
System 2. Tascam cd200, Terra Dac,Zbox,Decware Zen amp(V cap) Lowther PM6A in Acousta horns.
Maple rack, Brass footers,Power conditioner, dedicated treated room, iso pads, plenty of tubes. All cables DIY.

Pages: 1   Go Up
« previous next »