Glow test 2AU7

jake111 · 2179

« previous next »
Pages: 1   Go Down

0 Members and 2 Guests are viewing this topic.

Offline jake111

  • Full Member
  • ***
    • Posts: 98
on: March 15, 2019, 03:51:24 PM
I have the lower front and back of the 2AU7 glowing, the upper part only glows in the front. Is this normal?
Thanks, Jess


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 20174
Reply #1 on: March 15, 2019, 05:10:30 PM
That could be totally normal depending on the 12AU7.  Sometimes the placement of the heater inside the cathode sleeve isn't 100% consistent between halves (and it doesn't need to be).

-PB

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline jake111

  • Full Member
  • ***
    • Posts: 98
Reply #2 on: March 17, 2019, 11:01:27 PM
Finished and sounding great with HD 6XX.
The voltage test terminals that were supposed to be 0v were a bit higher.
3. 00.3v
6. 00.3v
8. 00.5v
10. 00.3v
Is this something to be concerned about?

Jess


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 20174
Reply #3 on: March 18, 2019, 04:26:51 AM
This is probably not an issue.  If your meter has different ranges, it may not resolve 0V very well on a setting like 200V. 

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline jake111

  • Full Member
  • ***
    • Posts: 98
Reply #4 on: March 18, 2019, 09:26:41 AM
The chassis plate gets pretty darn hot. Is there a temp range for that?


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 20174
Reply #5 on: March 18, 2019, 10:03:16 AM
Quote from: jake111 on March 18, 2019, 09:26:41 AM
The chassis plate gets pretty darn hot. Is there a temp range for that?
If you pass your voltage checks, the chassis plate temperature is appropriate.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Pages: 1   Go Up
« previous next »