Alps PCB

andyh · 2081

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline andyh

  • Jr. Member
  • **
    • Posts: 40
on: December 18, 2020, 05:55:02 AM
Could you recommend a PCB for an alps pot please, I found a couple, look totally diff' so looking for advice.

Thanks in advance.


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19764
Reply #1 on: December 18, 2020, 05:56:57 AM

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline andyh

  • Jr. Member
  • **
    • Posts: 40
Reply #2 on: December 18, 2020, 05:58:44 AM
Thank you, that was one of the ones I was looking at, will order, thanks for your prompt reply.


Offline Markkr

  • Full Member
  • ***
    • Posts: 70
Reply #3 on: December 20, 2020, 03:30:39 PM
I used the one linked above, worked perfectly!


Offline andyh

  • Jr. Member
  • **
    • Posts: 40
Reply #4 on: December 21, 2020, 06:14:08 AM
Quote from: Markkr on December 20, 2020, 03:30:39 PM
I used the one linked above, worked perfectly!

How did you connect it up?, looks pretty simple but doesn't hurt to check.


Offline Markkr

  • Full Member
  • ***
    • Posts: 70
Reply #5 on: December 21, 2020, 05:06:26 PM
While pictures are good (see attached)... I'd highly recommend breaking out the multi-meter and understanding the stock potentiometer, and mapping those functions to the Alps one. This is how I figured it out.


Offline andyh

  • Jr. Member
  • **
    • Posts: 40
Reply #6 on: December 21, 2020, 08:54:40 PM
Thanks Mark


Offline mightygrey

  • Jr. Member
  • **
    • Posts: 26
Reply #7 on: August 03, 2021, 12:38:40 PM


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19764
Reply #8 on: August 03, 2021, 02:22:36 PM

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Pages: 1   Go Up
« previous next »