BeePre2 high filament voltage... [resolved]

bernieclub · 571

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline bernieclub

  • Full Member
  • ***
    • Posts: 114
on: March 02, 2021, 10:56:14 AM
Just completed the board installation and I'm getting 8.45VDC on two meters.   High voltage measured 267VDC.    Any ideas?   T.I.A.

Bernie
« Last Edit: March 02, 2021, 11:14:41 AM by Paul Birkeland »

Bernie Zitomer

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19365
Reply #1 on: March 02, 2021, 11:07:32 AM
  You are measuring the "Reg" pads, not the "DC" pads right?

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline bernieclub

  • Full Member
  • ***
    • Posts: 114
Reply #2 on: March 02, 2021, 11:10:44 AM
Duh!   This is why you make the big bucks.   Voltages are correct.   Thanks

Bernie Zitomer

Pages: 1   Go Up
« previous next »