Mainline fine attentuator question

Happy Ghost · 4569

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Happy Ghost

  • Full Member
  • ***
    • Posts: 155
on: September 05, 2023, 07:36:40 AM
Hello All,

I am in the process of building my Mainline and I am right now on Page 57 of the manual. I was measuring the resistance after soldering both the 1472F resistors. Is it normal to get a reading of 0 ohms between the terminals 1 and 7 of the fine attenuator and their closest lower lug (where the resistors are soldered)? or did i do something wrong? :(

Thanks,
Atul

Atul

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19750
Reply #1 on: September 05, 2023, 09:49:21 AM
If you rotate the switch, that continuity will likely move to another pair of terminals.  This is normal and how the switch functions.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Happy Ghost

  • Full Member
  • ***
    • Posts: 155
Reply #2 on: September 05, 2023, 10:58:51 AM
Thank you Paul!

Atul

Pages: 1   Go Up
« previous next »