Sowter 1990 wiring

joralieu · 535

0 Members and 1 Guest are viewing this topic.

Offline joralieu

  • Full Member
  • ***
    • Posts: 102
on: December 20, 2023, 05:10:43 AM
So to wire the Sowter 1990 as a 1:10 step up I connect red to orange then white and gray go to the input?



Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19507
Reply #1 on: December 20, 2023, 05:49:30 AM
The general instructions on installing SUTs are here:
https://forum.bottlehead.com/index.php?topic=11097.0

Red to orange and white to grey will get you no signal out of the SUT.  For 1:10 operation, orange and red get soldered together and connected with heatshrink, grey goes into the solder cup on the pin of the RCA jack, and white to the ground tab on each RCA jack.  The pink, yellow, and black wires connect as described in the post above.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man


Offline joralieu

  • Full Member
  • ***
    • Posts: 102
Reply #2 on: December 20, 2023, 06:46:07 AM
Thank you